Terex 2025 Aerial Device Vehicles Recall for Overheating Risk
Areazine synthesizes this NHTSA vehicle recall directly from NHTSA's official public data feed. See our methodology for full source attribution and refresh cadence.
Terex South Dakota, Inc. is recalling certain 2025 aerial device vehicles due to a potential issue with the control valve that could cause hydraulic equipment to overheat, increasing the risk of burn injuries.
What this NHTSA vehicle recall tells you, and what most readers miss
This notice was issued by NHTSA on April 7, 2026 and geographically references United States. Its severity classification of "high" signals how the issuing agency weighs the risk of harm if no action is taken - "critical" and "high" tier alerts typically carry direct consumer actions, while "medium" and "low" tend toward informational guidance or monitoring advisories. The category it belongs to - Vehicle Recalls - determines the consumer-protection framework behind it, which shapes what remedies (refunds, replacements, repairs, or the recall itself) are available to affected consumers and which agency holds statutory responsibility for enforcement.
Most readers skim a notice like this, check whether they are personally affected, and move on. The more useful lens is to verify its scope, source, and timestamp, then compare related notices without assuming that one record proves a broader trend.
Areazine pairs this record with the original agency URL so you can check the primary source before acting. Its related labels are recall, product-safety, cpsc, Vehicle.
Terex Aerial Device Vehicles Recall
What Happened
Terex South Dakota, Inc. is recalling certain 2025 aerial device vehicles because the control valve may have been assembled with an incorrect plug, causing the hydraulic equipment to overheat.
Which Products Are Affected
The recall affects approximately 88 units of 2025 Terex TL-Series, LT-Series, LTM40, HR40, HR46, and SCM55 aerial device vehicles. The total affected units are 528, and the issue involves the equipment's mechanical boom/crane/ladder motor/hydraulic pump component. The NHTSA campaign number is 26V006000.
What You Should Do
Dealers will inspect and repair the control valve as necessary, free of charge. Owner notification letters were mailed on January 23, 2026. Owners may contact Terex customer service at 1-605-882-4000, and Terex's recall number is SN735.
Why This Matters
This recall addresses a hazard where overheated hydraulic equipment could lead to burn injuries, highlighting the importance of vehicle safety in industrial equipment.
Source
NHTSA Recall ID: 26V006000
Original source: NHTSA Official Notice ↗
Related Vehicle Recalls
All Vehicle Recalls →Nationwide notices with similar length or severity timing 8
Two Areazine-derived peer sets for this NHTSA vehicle recall: nearest notices by body length and by same severity near the same agency date. Peers come from other categories so they are not the same-feed Related list above.
Similar body length
Nearest notices by article body length (1,072 characters here).
Similar severity timing
Same severity (high) notices issued closest in time to April 7, 2026.
Frequently Asked Questions
Common questions about this NHTSA vehicle recall.