Terex Digger Utility Trucks Recall Over Weld Defect
Areazine synthesizes this NHTSA vehicle recall directly from NHTSA's official public data feed. See our methodology for full source attribution and refresh cadence.
Terex South Dakota, Inc. is recalling certain 2019-2026 digger utility trucks due to an insufficient weld that could cause the pole guide arm to fall and increase injury risk.
What this NHTSA vehicle recall tells you, and what most readers miss
This notice was issued by NHTSA on April 10, 2026 and geographically references United States. Its severity classification of "medium" signals how the issuing agency weighs the risk of harm if no action is taken - "critical" and "high" tier alerts typically carry direct consumer actions, while "medium" and "low" tend toward informational guidance or monitoring advisories. The category it belongs to - Vehicle Recalls - determines the consumer-protection framework behind it, which shapes what remedies (refunds, replacements, repairs, or the recall itself) are available to affected consumers and which agency holds statutory responsibility for enforcement.
Most readers skim a notice like this, check whether they are personally affected, and move on. The more useful lens is to verify its scope, source, and timestamp, then compare related notices without assuming that one record proves a broader trend.
Areazine pairs this record with the original agency URL so you can check the primary source before acting. Its related labels are recall, product-safety, cpsc, vehicle.
What Happened
Terex South Dakota, Inc. is recalling certain digger utility trucks because an insufficient weld on the plate weldment may crack, causing the retaining pin to separate and potentially allowing the pole guide arm to fall.
Which Products Are Affected
The recall involves 2019-2026 model year Terex General 65, General 80, General 95, C4000, C5000, and C6000 digger utility trucks equipped with pole guides. Approximately 2,303 units are affected, covering various model years from 2019 to 2026 as specified in the recall details. No specific model numbers, UPCs, or regional limitations are provided in the source data.
What You Should Do
Consumers should wait for owner notification letters, expected to be mailed on March 31, 2026. Take the affected vehicle to a dealer for a free inspection and replacement of the plate weldment if necessary. Contact Terex customer service at 1-605-882-4000 for more information, and reference Terex's recall number SN737.
Why This Matters
This recall addresses a safety issue that could lead to injuries from falling equipment, highlighting the importance of vehicle maintenance to prevent accidents during operation.
Source
NHTSA recall campaign number 26V167000.
Original source: NHTSA Official Notice ↗
Related Vehicle Recalls
All Vehicle Recalls →Nationwide notices with similar length or severity timing 8
Two Areazine-derived peer sets for this NHTSA vehicle recall: nearest notices by body length and by same severity near the same agency date. Peers come from other categories so they are not the same-feed Related list above.
Similar body length
Nearest notices by article body length (1,233 characters here).
Similar severity timing
Same severity (medium) notices issued closest in time to April 10, 2026.
Frequently Asked Questions
Common questions about this NHTSA vehicle recall.