Rolls-Royce Cullinan Recall: Loose Bolts May Compromise Rear Seat Safety

Source: NHTSA · United States

Areazine synthesizes this NHTSA vehicle recall directly from NHTSA's official public data feed. See our methodology for full source attribution and refresh cadence.

BMW of North America is recalling 102 Rolls-Royce Cullinan vehicles from model years 2020-2026 due to improperly tightened bolts that could damage seat belts.

What this NHTSA vehicle recall tells you, and what most readers miss

This notice was issued by NHTSA on April 4, 2026 and geographically references United States. Its severity classification of "high" signals how the issuing agency weighs the risk of harm if no action is taken - "critical" and "high" tier alerts typically carry direct consumer actions, while "medium" and "low" tend toward informational guidance or monitoring advisories. The category it belongs to - Vehicle Recalls - determines the consumer-protection framework behind it, which shapes what remedies (refunds, replacements, repairs, or the recall itself) are available to affected consumers and which agency holds statutory responsibility for enforcement.

Most readers skim a notice like this, check whether they are personally affected, and move on. The more useful lens is to verify its scope, source, and timestamp, then compare related notices without assuming that one record proves a broader trend.

Areazine pairs this record with the original agency URL so you can check the primary source before acting. Its related labels are recall, product-safety, nhtsa, Automotive.

What Happened

BMW of North America, LLC (Rolls-Royce) has issued a recall for certain Rolls-Royce Cullinan vehicles because critical fixing bolts may not have been properly tightened during assembly. These bolts can loosen over time, which may lead to damage of the left or right rear seat belt webbing. Additionally, the loose bolts could allow the rear backrest to move under pressure from items stored in the luggage compartment.

Which Products Are Affected

The recall affects approximately 102 units of the following vehicle:

  • Make/Model: Rolls-Royce Cullinan
  • Model Years: 2020, 2021, 2022, 2023, 2024, 2025, and 2026
  • NHTSA Campaign Number: 26V143000

What You Should Do

Owners are advised not to use the rear seats or the luggage compartment until the recall remedy has been completed. Authorized dealers will inspect, tighten, or replace the fixing bolts as necessary, free of charge. Dealers will also inspect the left and right rear seat belts and replace them if damage is found, also at no cost to the owner.

Owner notification letters are expected to be mailed by May 4, 2026. Owners may contact Rolls-Royce customer service at 1-877-877-3785 for further assistance.

Why This Matters

A damaged seat belt or an unsecured seat back may fail to adequately restrain a seat occupant during a collision. This defect significantly increases the risk of injury to passengers during a crash.

Source

Information provided by the National Highway Traffic Safety Administration (NHTSA) under Campaign Number 26V143000.

Original source: NHTSA Official Notice ↗

All Vehicle Recalls →

Frequently Asked Questions

Common questions about this NHTSA vehicle recall.

What is this NHTSA vehicle recall about?
BMW of North America is recalling 102 Rolls-Royce Cullinan vehicles from model years 2020-2026 due to improperly tightened bolts that could damage seat belts.
Which agency issued this alert?
This alert was issued by NHTSA. The original notice is available at the source link at the bottom of this article.
How severe is this alert?
This alert is classified as "high" severity. Take precautions and monitor for updates.
What area is affected?
This alert affects United States. Check with NHTSA for the most current geographic scope.
Where can I find more Vehicle Recalls updates?
Browse the full Vehicle Recalls feed on Areazine at areazine.com/recalls/vehicles/ for the latest updates from NHTSA and other agencies.